What can you develop?

For robot OEMs and hardware R&D teams

Custom robot joints

Building custom articulated arms
Prototyping limb joints and multi-joint mechanisms
Comparing actuator sizes for a new robot design

Compare for this application

For dynamic mechanism developers

Higher-speed motion

Faster rotating-mechanism prototypes
Dynamic swinging assemblies
Speed-focused joint comparisons

Compare for this application

Before you choose

Application guidance is based on the listed hardware and development resources. Confirm the software, sensors and integration your project needs.

Custom robot joints: what to confirm

Calculate load, inertia, thermal conditions and duty cycle. Confirm bearings, mounting flanges and mechanical differences between paired models before treating them as interchangeable.

Higher-speed motion: what to confirm

Check the torque-speed curve at your operating point, inertia, braking and bearing loads. Validate the complete mechanism at the intended speed.

TECHNICAL DATA

Specifications

Mechanical

Parameter	Value
Length and width	75 mm
Height	35 mm
Weight	390 g

Module Performance

Parameter	Value
Reduction ratio	7:1
Rated voltage	24 V
Rated current	5.6 A
Rated torque	4 N·m
Stall torque	12 N·m
Rated speed	250 rpm
No-load speed	270 rpm
Rated output power	92 W

Motor

Parameter	Value
Torque constant	0.602 N·m/A
Pole pairs	14

Electrical And Control

Parameter	Value
Voltage range	12 to 50.4 V
Peak current	20 A
Speed control accuracy	±10%
Torque control accuracy	±10%
Communication	CAN FD / CAN
Response time	140 µs
Input encoder resolution	14 bit
Output encoder resolution	14 bit
Bus bit rate	5 Mbps
Control frequency	3 kHz